Subject: Pulling a generator armature from '65 engine Sat 18 Aug 2007 - 16:22
Hello, I have to pull the armature from a '65 engine to clean it. The old shop manual says that you use an armature extractor screw, (part # 2205-VA) which I could make....
does anyone know the diameter and other particulars of this screw ?
Number of posts: 27 Age: 22 Localisation: France Registration date: 2007-05-01
Subject: Re: Pulling a generator armature from \'65 engine Fri 31 Aug 2007 - 7:23
Hi Rob,
unfortunately, I can't help you because I don't see what it resembles.... But maybe, if you can photocopy the manual shop, I can help you, Maybe I have it in my garage....
Subject: Re: Pulling a generator armature from \'65 engine Wed 24 Oct 2007 - 22:38
Jim,
Thank you for the link. I can see that the tool is about what I expected... If I knew the pitch and diameter of the screw/bolt, I could turn a tool on my lathe. I did not know one could even buy the tool, though.
much to do on my little green wonder , the 57 2cv....
Subject: Pulling a generator armature from '65 engine 
